The rear of the block lid should fit over the front lip of the sliding rear cover.Ħ. Lower theįront portion of the reaction block so that it engages with the chassis before the rear portion. Lift the optical reaction block by the handle and install it onto the chassis. Rotate the green latches on the optical reaction block up towards the open lid.ĥ. Push the sliding rear cover on top of the chassis as far back as possible.Ĥ. That the notch is oriented towards the rear of the iCycler thermal cycler.ģ. Install the modified sliding rear cover provided with the optical reaction block, ensuring Remove the existing rear cover from the iCycler chassis by sliding the cover towards theĢ. Optical-quality sealing film or tube capsġ.2.2 Installing the Optical Reaction Module on the iCycler Chassisġ. The following accessories are required to complete the installation: External well factor solution (5 tubes) Sample ConsumablesĬontact your local Bio-Rad office if any system components are missing or damaged.MyiQ2 Calibrator Dye Solution Kit (catalog #170-8791)ġx calibration dye solutions (4 dyes, 3 tubes of each dye)Įxternal Well Factor Solution (catalog #170-8794) Modified sliding rear cover for iCycler thermal cycler IQ5 Optical Accessory Kit (catalog #170-9752)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |